cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4185
Views
0
Helpful
4
Replies

attendant DN versus DN

alex goshtaei
Level 1
Level 1

Hi All,

I've setup VG224 with 24 FXS ports. each port has attendant DN and also DN which can be assigned to that port. what's the difference between these two? I know in FXO port, attandant DN is similar to connection plar.

thanks

Alex

1 Accepted Solution

Accepted Solutions

Hi

When you add the ports you get a choice of loop start/ground start or POTS - POTS is your friend; did you select one of the others?

Aaron

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!

View solution in original post

4 Replies 4

Rob Huffman
Hall of Fame
Hall of Fame

Hi Alex,

For the VG224 the Attendant DN field can be left blank

It appears to be some sort of legacy/remnant left over from the VG200

days in reference to FXO Ports like you nicely noted. Here is a reference

that may help;

How to Configure Cisco VG 224 Analog Voice Gateway Using Cisco Unified Communications Manager Bulk Administration Tool

http://cisco.biz/en/US/products/sw/voicesw/ps556/products_configuration_example09186a0080b2592e.shtml


Cheers!
Rob

Please support CSC Helps Haiti

https://supportforums.cisco.com/docs/DOC-8895

https://supportforums.cisco.com/docs/DOC-8727

thanks for your reply,

but attendant DN is the mandatory field and it can't be blank.

any idea?

thanks again

Hi

When you add the ports you get a choice of loop start/ground start or POTS - POTS is your friend; did you select one of the others?

Aaron

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!

Does seem misleading, been a while since I've worked with a VG224.

I don't have one to test but from what I read and reviewed in a CUCM 8.x this happens when you have selected a MGCP FXS.

For FXS you need to choose:

POTS

Ground Start

Loop Start

The documentation doesn't explain this but apparently you need to use POTS for phones, the other 2 options are meant for trunk lines.

This to address a bug:

CSCse23808
CCMAdmin should support MGCP-controlled analog FXS GroundStart endpoints

But generated another bug to remove that attendant DN and avoid confussion

CSCtf22348
MGCP FXS GroundStart and LoopStart need Prefix DN; remove Attendant DN

So, apparently attendant DN under GS/LS is useless. What you need to use is prefix DN for PLAR from what I read.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate