10-22-2015 08:06 AM - edited 03-17-2019 04:39 AM
i have a cluster consists of CUCM Publisher and two CUCM Subscribers , auto registration is disabled on Publisher and enabled on Subscriber 1 and subscriber 2, also i have tow CM Groups as below :
CMGROUP1 :
subscriber 1
subscriber 2
Publisher
Auto registration Enabled.
CMGROUP2:
subscriber 2
subscriber 1
Publisher
Auto registration Disabled.
now for Auto-registration if i put subscriber 1 and subscriber 2 on NONE partition phones get extension and working fine, if i put subscriber 1 and subscriber 2 in PT-INTERNAL it is not able to get extension , please advise any got this problem before?
Solved! Go to Solution.
10-22-2015 08:59 AM
Are you sure that those extensions are not already present in your cucm database..
Use route plan report to check that these extensions range don't already exist
10-22-2015 09:17 AM
Hi there,
Just a note to add to the good ideas from my friend Deji (+5 Deji!)
Any time Auto-Registration is disabled the Partition setting for Auto-Registration DN's gets reset to "None" so I would have a look at the Partition setting on the Auto-Registration config page and change to the one you desire to use ie; PT-Internal in your case.
http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/7_1_2/ccmcfg/bccm-712-cm/b02autor.html
Cheers!
Rob
10-22-2015 01:27 PM
Hi Rob (+5)..Great to catch you hear again..Long time ( I have been mostly out..). Hope you are keeping well..
10-22-2015 08:59 AM
Are you sure that those extensions are not already present in your cucm database..
Use route plan report to check that these extensions range don't already exist
10-26-2015 01:17 AM
thanks all persons , i deleted the numbers from Call routing ----> Directory Numbers , the numbers descibed as Auto, around 100 numbers Deleted , it works well.
10-26-2015 02:16 AM
Glad to know its working..Please mark the answer as correct to help others in the future
10-22-2015 09:17 AM
Hi there,
Just a note to add to the good ideas from my friend Deji (+5 Deji!)
Any time Auto-Registration is disabled the Partition setting for Auto-Registration DN's gets reset to "None" so I would have a look at the Partition setting on the Auto-Registration config page and change to the one you desire to use ie; PT-Internal in your case.
http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/7_1_2/ccmcfg/bccm-712-cm/b02autor.html
Cheers!
Rob
10-22-2015 01:27 PM
Hi Rob (+5)..Great to catch you hear again..Long time ( I have been mostly out..). Hope you are keeping well..
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: