03-18-2009 02:55 AM - edited 03-15-2019 04:55 PM
We have some phones in the corridor of a shop which are used by the customers to contact to the operator (hunt group 1090, with two extensions, 1000 and 1001). I would like to configure the phones to dial directly to 1090 (or 1000 if it doesn't work) when the phone goes off-hook. If it is not possible, could I configure a direct access (for example dialing 0) to connect to 1090 or 1000? The CCM version is 5.1(2).
Best regards.
Solved! Go to Solution.
03-18-2009 05:32 AM
Hi Victor,
The step by step directions in this guide are very good (the principles should carry over nicely) :)
Hotdial on IP Phones with CallManager Configuration Example
Hope this helps!
Rob
03-18-2009 04:21 AM
I think the best way for u is to use PLAR ( Private Line Autmatic Ringdown ) pointing to your hunt pilot.
03-18-2009 04:39 AM
Hello, thank you for your response. The problem is that the phone in which I want to configure the automatic dial is an analogue phone attached to a FXS port in a 2851 and MGCP-controlled. So I think I can't configure PLAR in Call Manager (this functionality is for IOS Gateway).
Regards.
03-18-2009 05:32 AM
Hi Victor,
The step by step directions in this guide are very good (the principles should carry over nicely) :)
Hotdial on IP Phones with CallManager Configuration Example
Hope this helps!
Rob
03-18-2009 07:00 AM
Hi Rob, thank you for the useful information, it is exactly what I need. I tried to do that, but I think it did not work because of partitions and CSS. Now it is working perfectly.
Best regards.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide