Bearer-cap speech command implementation

[K D]

Hi there,

I have got few 8945 handsets not able to complete a call over the pstn(pri). On debugging, I found that I need the command

"bearer-cap speech"  on the voice port. I wanted to understand the implications on the applying this command on the interface on production network?

when applying this command 

1. Will the active voice call disconnect?

2. Do I need to do an shut and no shut on the voice port for the command to become active?

[Rajkumar Yadav · Accepted solution]

Hi Kingslin,

I have applied this command on many router due to DX650 phones.

No reset required, just put the command under voice-port and rest all will be normal.

two option available bearer-cap speech or 3100 

I did 3100 and all fine.

Regards,

Raaj.

[Carlo Poggiarelli · Accepted solution]

Hi David.

When you issue that command on voice port, no call is impacted and you don't need to shut the port to make it active.

HTH

Regards

Carlo