cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

442
Views
0
Helpful
3
Replies
Beginner

Blocking specific incoming number MGCP CUCM 7

We have CUCM 7.1.5.20000-6 and use MGCP. As I recall 8 has a feature to block using translation patterns but not sure if this is possible using versions lower than 8.

So just looking to confirm if CUCM 7.1.5.20000-6 using MGCP can block a call based on the calling party number.                  

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Community Legend

Blocking specific incoming number MGCP CUCM 7

Hi Nishant,

You are most correct my friend, with MGCP you need a minimum

of CUCM 8.x

From Dan @ Cisco for MGCP

https://supportforums.cisco.com/docs/DOC-18367

Cheers!

Rob

"Talk about a dream
Try to make it real" 

- Springsteen

View solution in original post

Highlighted
Advisor

Blocking specific incoming number MGCP CUCM 7

Hi ,

I think u are looking for Route Next Hop by Calling Party number .

regds,

aman

View solution in original post

3 REPLIES 3
Hall of Fame Community Legend

Blocking specific incoming number MGCP CUCM 7

Hi Nishant,

You are most correct my friend, with MGCP you need a minimum

of CUCM 8.x

From Dan @ Cisco for MGCP

https://supportforums.cisco.com/docs/DOC-18367

Cheers!

Rob

"Talk about a dream
Try to make it real" 

- Springsteen

View solution in original post

Highlighted
Advisor

Blocking specific incoming number MGCP CUCM 7

Hi ,

I think u are looking for Route Next Hop by Calling Party number .

regds,

aman

View solution in original post

Beginner

Blocking specific incoming number MGCP CUCM 7

That's what I was afraid of.

Thanks for confirming - back to the drawing board!

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here