12-11-2008 08:05 AM - edited 03-15-2019 03:02 PM
Hello,
I changed the IP address of the subscriber callmanager and as such the subscriber callmanager and the callmanager service hardly stays at an active state.
Clustering is not working since all the devices are registered to the publisher.
How can i resolve this?
Please help,i have never seen this before-i thought it should'nt be a problem with callmanager 6.1
Please help,i have limited time to implement this project.
Thanks.
12-11-2008 08:41 AM
Hi Nicholas,
Did you change the Sub's IP Address reference in the Publisher?? The steps are shown here;
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/install/6_1_2/ipchange/ipchg612.html#wp186132
Hope this helps!
Rob
12-11-2008 10:49 PM
Hello,
It seems to be working ok today,
i actually did'nt go through all the steps in this procedure-i did restart all the servers in the cluster.After doing this,all was okay.
Am monitoring the situation.
Thank You.
12-11-2008 08:42 AM
Unless you following the documented steps for changing the IP address, then you will certainly run into problems:-
Changing CallManager IP Address:-
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/install/6_1_2/ipchange/ipchg612.html
You need to ensure that you change the server configuration IP address in CallManager before changing via the CLI?
Can you kindly confirm whether you followed these steps, it will help determine where the issue resides?
Regards
Allan.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide