04-27-2010 10:17 PM - edited 03-15-2019 10:30 PM
Hi to everyone,
It would be greatful if you guys guide me here pls..
Can we run both mgcp and h323 protocols in a single voice 3845 gateway router ?
thanks
shiv
Solved! Go to Solution.
04-27-2010 11:27 PM
Hi Siva
I don't believe I've ever read anything that recommends against this.
However I have seen customers with this setup, I'm not sure exactly what your trying to do but from experince the only issue I have ever seen with this is where there is srst configure using: application mgcpapp
The reason is if you put a h323 dial-peer before the application mgcpapp dial-peer, it will never invoke the MGCP dial-peer as it looks from a top down order.
You may beable to change with this the dial-peer hunt however if you order your H323 dial-peer after the application mgcpapp
you shouldnt' have any issues.
04-28-2010 02:09 PM
Hi
The MGCP autogenerated dial-peer prefix can be changed if so desired, ordinarily MGCP dial-peers are generated as 999????. The following command allows you to change this prefix, however as already stipulated you need to be wary of the order in which they are created:-
ccm-manager config dialpeer-prefix prefix (select a prefix number other that the default 999)
Regards
Allan.
Hope this helps, pls rate helpful posts.
04-27-2010 10:19 PM
Yes, this is done all of the time. Well, maybe not all of the time but enough to make it a common place configuration.
HTH.
Regards,
Bill
Please remember to rate helpful responses and identify
04-27-2010 10:42 PM
Thanks for your quick reply.But couldnt get a single document which illustrates such scenario.
Is it a recommended / advisable by Cisco ?
thanks
04-27-2010 11:27 PM
Hi Siva
I don't believe I've ever read anything that recommends against this.
However I have seen customers with this setup, I'm not sure exactly what your trying to do but from experince the only issue I have ever seen with this is where there is srst configure using: application mgcpapp
The reason is if you put a h323 dial-peer before the application mgcpapp dial-peer, it will never invoke the MGCP dial-peer as it looks from a top down order.
You may beable to change with this the dial-peer hunt however if you order your H323 dial-peer after the application mgcpapp
you shouldnt' have any issues.
04-28-2010 12:03 AM
Oh;Ok.
Thank you so much guys for your quick update.
04-28-2010 02:09 PM
Hi
The MGCP autogenerated dial-peer prefix can be changed if so desired, ordinarily MGCP dial-peers are generated as 999????. The following command allows you to change this prefix, however as already stipulated you need to be wary of the order in which they are created:-
ccm-manager config dialpeer-prefix prefix (select a prefix number other that the default 999)
Regards
Allan.
Hope this helps, pls rate helpful posts.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide