cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
407
Views
0
Helpful
2
Replies
Highlighted
Beginner

Cannot see caller ID on cisco 7911 phone

Hi all,

I have configured a cisco 7911 with the following configurations:

ephone-dn  40  dual-line

number 999 no-reg both

label Faith_Test 999

name Faith_Test

corlist incoming In000-002-98

huntstop channel

ephone  40

device-security-mode none

mac-address 1111.2222.3333

username "Faith_Test" password Cisco

type 7911

button  1:40

Problem is that when i am talking on the phone then there is a second incoming call, i cannot see the caller ID hence i cannot call back. is it possible to fix this error?

Everyone's tags (7)
1 ACCEPTED SOLUTION

Accepted Solutions
Advocate

Cannot see caller ID on cisco 7911 phone

Faith,

In your ephone-dn config

!

ephone-dn  40  dual-line

number 999 no-reg both

label Faith_Test 999

name Faith_Test

corlist incoming In000-002-98

huntstop channel

!

huntstop channel

This should mean that if this line/DN is in use then any futher calls to this number should receive busy tone

If you want to have call waiting then you need to remove the huntstop.

!

ephone-dn  40  dual-line

no huntstop channel

!

Now if the line/DN is in use a second caller should hear ring tone and the phone user should hear a bleep

every few seconds indicating that a new caller is waiting.

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.
2 REPLIES 2
Advocate

Cannot see caller ID on cisco 7911 phone

Faith,

In your ephone-dn config

!

ephone-dn  40  dual-line

number 999 no-reg both

label Faith_Test 999

name Faith_Test

corlist incoming In000-002-98

huntstop channel

!

huntstop channel

This should mean that if this line/DN is in use then any futher calls to this number should receive busy tone

If you want to have call waiting then you need to remove the huntstop.

!

ephone-dn  40  dual-line

no huntstop channel

!

Now if the line/DN is in use a second caller should hear ring tone and the phone user should hear a bleep

every few seconds indicating that a new caller is waiting.

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.
Beginner

Re: Cannot see caller ID on cisco 7911 phone

Hi Alex!

Thank you! This sorted the issue! The phone is working alright.

Sent from Cisco Technical Support iPhone App

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards