Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I have done a lot of research regarding the best antennas for the warehouse but would like to hear your views on what I have chosen. We are deploying in the warehouse and the ceiling is 10m high. We will be installing the 3700e and am eyeing ...
Guys, Please assist. We got a new replacement for existing 4500 SW to 4506E. I have just noticed that the confreg is 0x2101 instead of the usual 0x2102. After reading documentation, i understood that the two confregs are basically one and the same th...
Guys, I have a question regarding LAG ports. From Rajan's post here https://supportforums.cisco.com/document/81681/lag-link-aggregation he mentioned the following: When you enable LAG, all ports participate in LAG by default. Therefore, you must conf...
Hello All, Am planning on upgrading the WLC to the latest version. Problem is that our terminal server went kaput on us last week so i do not have console access to the WLC. The release notes show that both the FUS and the image can be upgraded via t...
Guys,Please help me understand this. I am used to getting access points with omnidirectional antennas, however, i need an AP that can be placed on the wall (not ceiling) and send the signal in a certain direction only. For 3700i, the signal is basi...
Hi, I had a similar behaviour with Cat4500E. TAC told me to upgrade the IOS because it looked like a bug. Usually, a reboot would help as an immediate remedy. We checked the memory, the processes, the lines and all looked ok. My advice is therefore, ...
I would start by connecting to it via server console to see what the error is or where it is getting stuck. Can you ssh or telnet to it? Is the CPI pingable?
Hello,Is this a new deployment or an existing one? Were there some changes that were made that could have caused this (new IOS)?Could you upload screen captures of the error?
Hey Scott,Thank you for taking your time to reply. 1) What is the safe distance for the small profile omnis? Like up to 6 m up ?2) Read an earlier comment where you mentioned that best to use patches if you have a height of about 50" due to the signa...
The smartnet covers the WLC so if you have one that supports up to 100 APs, you get the smartnet for 100 APs even if you are using eg. 5 APs. With that in mind, you will need to go for the 50 one. Refer to table 3http://www.cisco.com/c/en/us/products...
