07-15-2015 09:50 AM - edited 03-17-2019 03:39 AM
I just installed 2 new VG204XM gateways that are functioning fine but I cannot telnet or ssh to them. I can only connect via the console port.
Their config was copied from a VG204 and then only the host name, ip, etc was changed to reflect the location I installed in.
How can I enable telnet or ssh on these 2 devices?
07-15-2015 10:21 AM
please refer to below document
http://www.cisco.com/c/en/us/td/docs/routers/access/vg202_vg204/quick/vg2_4qsg.html
Br,
Nadeem
07-15-2015 10:49 AM
This document has no information on enabling remote access at all.
I would like the CLI commands to configure outside of the initial setup.
11-10-2016 02:56 PM
Marc,
Did you ever resolve with being able to SSH to your VG204XM? I have one setup and working fine via telnet, but I want to disable telnet access and enable SSH for security reasons. The standard CLI command of "transport input ssh" is not being accepted on the VG204XM.
Thanks,
Paul
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide