cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
307
Views
0
Helpful
5
Replies
Highlighted
Beginner

CCM 5.04 with H.323 gateway ringback tone question

Hi,

I have configured in CCM an Ericsson H.323 gateway (for use Ericsson DECT Phones) when an Ericsson phone calls to an Cisco IP phone i don't hear ringback tone, but if ip phone is busy i hear busytone. From cisco ip phone to Ericsson phone its ok.

Can i setup something in CCM to force ringback tone when Ericsson phone calls to cisco ip phone??

Thanks

Best Regards.

MC

5 REPLIES 5
Highlighted
Participant

Re: CCM 5.04 with H.323 gateway ringback tone question

Is this problem associated only with Ericsson DECT phones associated with cisco ip phones? Configure the Ciso IOS command progress_ind setup enable 3 under the voice dial-peer# voip command in the Cisco gateway.

Highlighted
Beginner

Re: CCM 5.04 with H.323 gateway ringback tone question

Hi,

I have done that, yet.

For external calls (calls to PSTN) calls from DECT phones goes through cisco GW and i don't have that problem. Only for internal calls from Ericsson DECT phone to cisco IP phones. In that case calls don't go through cisco gateway so i don't ear ringback tone, but if ip phone is busy i ear busy tone.

BR,

MC

Highlighted
Beginner

Re: CCM 5.04 with H.323 gateway ringback tone question

Highlighted
Beginner

Re: CCM 5.04 with H.323 gateway ringback tone question

Hi,

I think i have to change Send h225 user info message in CCM service parameter,

what would be better

User info h225 or h225 info or ANN? Do i have to restart CCM service after change?

BR,

MC

Highlighted
Beginner

Re: CCM 5.04 with H.323 gateway ringback tone question

Hello,

I would like to set-up an Ericsson switch (MX-ONE Telephony switch, currently distributed under AASTRA brand) as a H.323 gw in CUCM 6.1.2. Unfortunatelly I failed in this. Would you be willing to share some experience?

Thank you.

Mirek

CreatePlease to create content