Changing Service Parameter Configuration in CUCM required any restart?

[MehmetKaya]

Hi All,

From CUCM 8.5.x If I have changed any configuration on "service parameter configuration". Is it required the any service or cucm restart?

Path:

CUCM CM Administration >> System >> Service Parameters >> Call Manager ...

[Aaron Harrison]

Hi

In general, most apply immediately. Some may not - certainly for some of the other services a restart is required.

What specific parameters are you changing?

Aaron

Aaron Harrison

Principal Engineer at Logicalis UK

Please rate helpful posts...

[MehmetKaya]

"CDR Enabled Flag"  make enabled

" CDR Log Call with Zero Duration Flag" make disabled

also

I think If any changes required the reset or restart there is a pop-up will appears isn't is?

[Aaron Harrison · Accepted solution]

Hi

Those changes do not require a restart.

Regards

Aaron

[MehmetKaya]

Thanks.

[kfbaluyut17]

Hi @Aaron Harrison 

Hope you're doing fine. I would like to make changes on the Auto Answer Timer. Does this require a restart? Does Cisco have a list or documentation for the services that requires and does not require a service restart?

Thanks!

Ken

[Roger Kallberg]

No and not that I’m aware of to answer your respective questions.

[ziqex]

Hello,
I wonder if the following parameter require the restart of any services.
Local route group for redirected calls. Thank you.