Cisco 2901 + HWIC-4B-S/T - doesn't show voice-port

[Paul van den IJssel]

Hi,

I'm currently working on a getting a Cisco 2901 to work as a voice gateway with a HWIC-4B-S/T. It's running IOS 15.0(1r)M16 (c2900-universalk9-mz.SPA.154-3.M3.bin).

In order to route my calls to the correct BRI ports, I need to assign a port (voice-port) to the pots dial-peer. In my old Cisco 2801 config it looked like this:
!
dial-peer voice 100 pots
 preference 1
 destination-pattern 0.!
 port 0/0/0
!

Which points to the voice-port:
!
voice-port 0/0/0
 translation-profile incoming FROM_ISDN
 translation-profile outgoing TO_ISDN
 no vad
 compand-type a-law
 cptone NL
!

But in with this new Cisco 2901 I don't get to see the "voice-port 0/0/0". I already tried looking it up within the IOS documentation and other Cisco doc's. But no luck.

show inventory ouput:
NAME: "CISCO2901/K9", DESCR: "CISCO2901/K9 chassis"
NAME: "4-port Wan Interface Card BRI S/T on Slot 0 SubSlot 1", DESCR: "4-port Wan Interface Card BRI S/T" HWIC-4B-S/T
NAME: "PVDM3 DSP DIMM with 32 Channels on Slot 0 SubSlot 4", DESCR: "PVDM3 DSP DIMM with 32 Channels"


Regards, Paul

[Aman Soi · Accepted solution]

Hi Paul,

you need to have VIC2-2BRI-NT/TE card for voice functionality.

http://www.cisco.com/c/en/us/products/collateral/interfaces-modules/ip-communications-voice-fax-network-modules/product_data_sheet0900aecd801c595e.html

the ISDN card which which u are using is for Data.

regds

aman

[Paul van den IJssel]

Thanks Aman!

[Dennis Mink]

Nice!!! prutser!