Cisco 7925g Connection failed

[YAARUB F. MILAD]

Hello ,,

After configuring VoWLAN as per the following document:

Voice over Wireless LAN 4.1 Design Guide

and adding a network profile on the 7925g wireless phone . I still get connection failed .

For those who had faced this issue before please comment any propable troubleshoot for this .

This issue is delaying a project delivery, so its urgent

Thanks all

[Leo Laohoo]

Describe your WLAN configurations and settings.

What is the error message when the phone tries to connect?

[NicP270591]

Hi,

Further to what Leo has said:

What model of the 7925G are you using specifically? eg. CP-7925G-A-K9, CP-7925G-W-K9, CP-7925G-E-K9 etc

What country is the phone being deployed into?

if it is a W model, the AP will need world mode configured on the Dot11Radio interface to register with the network.

conf t

int Dot11Radio1

world-mode dot11d country XX (both, indoor, outdoor)

end.

It sounds like an identical issue I dealt with last week, and this solved the issue. Also check obviously the phone has the correct SSID (case sensitive) and password, as well as security mode.

HTH,

Nic.

[shankarn]

Thanks Nic. The command fixed my issue.

[NicP270591]

You're welcome, glad I could help.

[Muaaz El Kamali]

Hi Nic,

How can I configure interface dot11 on lightweight access point??