cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5620
Views
0
Helpful
6
Replies

Cisco CME time zone. How to remove daylight time

netone.cisco
Level 1
Level 1

Hello all,

Our company has CME v7.1 running on a 3845. Our phones are mostly 7906 and 7911. I live in Angola, a country with GMT+1 time. We dont have Daylight Savings Time and our time is constant the whole year. Time is displayed correctly except it changes along the year.

The list of time under telephony service only have +60(min) time zone with Daylight time (check below)

Is there anyway to remove the DST just like "clock set" on exec mode?

Thanks very much

    rw-ld-sede-01(config-telephony)#time-zone ?

      <1-53>  select timezone name used by IP phones (offset in minutes)

    1 Dateline Standard Time -720

    ...

    18 SA Eastern Standard Time -180

    19 Mid-Atlantic Standard/Daylight Time -120

    20 Azores Standard/Daylight Time -60

    21 GMT Standard/Daylight Time +0

    22 Greenwich Standard Time +0

    23 W. Europe Standard/Daylight Time +60

    24 GTB Standard/Daylight Time +60

    25 Egypt Standard/Daylight Time +60

    26 E. Europe Standard/Daylight Time +60

    27 Romance Standard/Daylight Time +120

     ...

1 Accepted Solution

Accepted Solutions

paolo bevilacqua
Hall of Fame
Hall of Fame

If there is no correct TZ, you will have to manually change time twice a year.

View solution in original post

6 Replies 6

paolo bevilacqua
Hall of Fame
Hall of Fame

If there is no correct TZ, you will have to manually change time twice a year.

Paolo,

Thanks for your time.

Really? I have seen information talking about "locale" installation for different languages. Is there no way to install new time-zones?

As mentioned before:

There is NO way.

Please remember to rate useful posts clicking on the stars below.

Thanks Paolo,

I'll just have to keep changin then. Anywhere I can make feature requests to CISCO?

netone.cisco wrote:

Thanks Paolo,

I'll just have to keep changin then. Anywhere I can make feature requests to CISCO?

You could, but it's mostly wasted time.

Thanks for the nice rating, and good luck!

Hi,

Quick question from a newbie : I'm facing the same issue, so how do you manually change the time on CME ?

Thanks

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: