06-14-2019 11:03 AM
Good Morning All,
I am trying to register an extension to a phone as it went faulty and needed replacement.
Both phones were registered before, so here is what I did:
17 wasn't being used and I change the mac address for 12.
All good for now, however, my Cisco Unified Communications Manager Express does not allow me scroll down to the desired extension as shown bellow.
I would like to do it through Command Line but I cannot find my way through.
How do you register an extension on a phone through Command Line?
Thank you in advance for the response. J
06-14-2019 11:33 AM
Read here:
You already have your current configuration for guidance to match against the documentation.
06-16-2019 02:43 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide