08-19-2016 09:05 AM - edited 03-17-2019 07:53 AM
Hello,
we have some Cisco VG320s, controlled in SCCP by a CUCM 10.x.
We would like to know if we can configure the call transfer feature to be implemented without the use of the hookflash.
TIA and regards.
Solved! Go to Solution.
08-20-2016 09:10 AM
Table 1
08-19-2016 04:46 PM
AFAIK, you canno't perform transfer without using hookflash.
Br,
Nadeem
08-20-2016 12:28 AM
Agreed with Nadeem. On loop start systems you need to use hookflash to signal call transfer.
08-20-2016 01:19 AM
Hello Nadeem,
thank you for your answer.
Could you provide us the reference to an official document, please?
Thanks again and best regards.
08-20-2016 09:10 AM
Table 1
08-20-2016 11:50 AM
Thank you Jaime for your contribution! :-)
In the meantime, I already had found this document, but I was hoping that there was another way to make the call transfer without using the hookflash... ;-)
Thanks again! :-)
Best regards.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide