cme connection problem

[gevangelista]

Good Morning I've a little problem with a cme and fxo card.

well.

I've a callmanager express, that work.

I've also another router  wher are connected all analogic lines and faxes. connected via sip trunk to callmanager express.

On this second router I've installed a fxo card directy connected to a fxs port of an UMTS router.

Our customer want tha all call directed to a mobile devices will be router from callmanager to the fxo port of second router.

I've implemented the following configuration. but the calls doesn't works.

can you help me?

thanks in advance

CCME

dial-peer voice 1340 voip

destination-pattern 89T

session target ipv4:172.16.3.91

dtmf-relay h245-alphanumeric

no vad

second router (with fxo card)

dial-peer voice 1340 voip

destination-pattern 89T

session target ipv4:172.16.3.90

dtmf-relay h245-alphanumeric

no vad

!

dial-peer voice 1340 pots

destination-pattern 89T

port 0/1/0

!

T voice-port 0/1/0

no comfort-noise
cptone IT

[Bruno Rangel]

Hi try in the second Router shutdown the dial-peer voice 1340 voip.

Let me know if woks...

Cheers
Bruno Rangel

"Se você quiser alguém em quem confiar, confie em si mesmo. Quem acredita sempre alcança"
Renato Russo

[gevangelista]

Hi Bruno , now the dial-peer 1340 on second router is shutdowan but doesn't work!

[Bruno Rangel · Accepted solution]

Please post the output of debug voip ccapi inout,

Give us the called number and calling number and exctly as you is dialing

Cheers
Bruno Rangel

"Se você quiser alguém em quem confiar, confie em si mesmo. Quem acredita sempre alcança"
Renato Russo

[Chris Deren · Accepted solution]

Is 89 supposed to be stripped as pots dial-peers strip all explicitly matched digits, in your case 89 will both be stripped before sending the call to PSTN.

Can you also post "debug voice dialpeer" from both routers?

Chris

[gevangelista]

Hi. I've solved!!!

The problem was an old  dial-peer  configured but not used on second  router.

I've put in shutdown this dial peer and now alla works!!!

Thanks for help

giancarlo