01-28-2011 10:44 AM - edited 03-16-2019 03:08 AM
Hi
CallManager Express 8.0 with E1 PRI and DID numbers.
Also there is CUE module exits in this router. Router IOS is 15.x
How do we configure Dial peers to prevent call fraud from unauthorized sources?
Rgds
Rajesh Kumar
01-28-2011 11:22 AM
01-30-2011 01:15 AM
Hi clileikis
I have gone thorough the link, one you attached.
trust list under, voice service voip is for VOIP calls right.
there is one command : dial-peer no-match isdn disconnect-cause invalid-number
This command will disconect not matching dial-peer or default dial-peer. Do you have any solution for matched dial-peer (phone does not exists, but ephone configured), in that scenario CME should not provide outside dial-tone.
Pls. suggest if anything else need to be configured prevent call fraud.
Rgds
Rajesh Kumar
01-30-2011 01:15 AM
Hi clileikis
I have gone thorough the link, one you attached.
trust list under, voice service voip is for VOIP calls right.
there is one command : dial-peer no-match isdn disconnect-cause invalid-number
This command will disconect not matching dial-peer or default dial-peer. Do you have any solution for matched dial-peer (phone does not exists, but ephone configured), in that scenario CME should not provide outside dial-tone.
Pls. suggest if anything else need to be configured prevent call fraud.
Rgds
Rajesh Kumar
01-30-2011 02:07 AM
Hi Rajesh,
Have I worked with you on a TAC Case?
you could use
dial-peer voice 1 pots
incoming called-number .T
direct-inward-dial
This should get rid of the secondary dial-tone.
HTH
PS: Rate useful posts.!
01-30-2011 03:02 AM
Hi
Thanks for information.
Good you remember me.
Rgds
Rajesh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide