Commands to Verify Transcoder config and sessions.

[wrightmp]

I have configured numerous 28XX for transcoding resource on various versions of callmanger and they work fine. However I have never been able to view the live transcoding rtp sessions as they occur on the router (28XX). I know that the transcoder is doing its job - as i can browse to the IP address of the Cisco phone and see that it rtp stream terminates on the transcoding router (28XX). I would however love to know the command to view the transcding sessions that are currently being used on the router (28XX). I have tried many show commands that i can see on the router without success, Can any one help??

Over the years I have used various levels of IOS - so I am sure its not a buggy IOS.

Thanks In advance Mark

[Rob Huffman]

Hi Mark,

Have you tried;

show voice dsp group all

show voice dsp detailed

show dspfarm dsp active

Hope this helps!

Rob

[wrightmp]

Hi - I will try and update all.

Many Thanks Mark

[Steven Holl]

I prefer 'sh sccp conn' for this.

[William Bell]

Mark,

Wouldn't "show sccp connections" give you the data you are looking for? Or

is there something missing? I know I have used it for TRP/MTP and CFB

recently. Can't recall the last time I looked at a hardware transcoded

session.

HTH.

Regards,

Bill

On 9/9/10 12:53 PM, "wrightmp"