07-15-2010 10:58 AM - edited 03-15-2019 11:44 PM
Will someone point me to a configuration for FXS ports on a Cisco h323 gateway. We are using CCM 4.2.
These analog lines should be able to call outside via 9xxx-xxxx, 91xxx-xxx-xxxx, make 5 digit dialing 1xxxx, 2xxxx. Thanks
07-15-2010 11:15 AM
Hello friend,
This is FAQ. You can use the search tool.
You can follow this document: http://www.cisco.com/en/US/docs/ios/voice/fxs/configuration/guide/fxssccpsplmft.html
Hope it helps, please rate if it helps.
Kind regards,
- Adrian.
07-15-2010 11:28 AM
This is on a Cisco 1900 router. These anlog lines will be used for faxing only.
07-15-2010 11:34 AM
07-15-2010 11:39 AM
I can call the fxs port from a cisco phone but I cannot call out from FXS lines.
07-15-2010 03:39 PM
Hello,
Sorry, I didn't find the show run...
Kind regards.
07-16-2010 05:23 AM
07-16-2010 09:02 AM
Hello,
I can see the file. Thanks. Let's see what dialpeers are matching when calling from your fax devices. For each call, please take debug voip ccapi inout.
Kind Regards.
07-26-2010 11:49 AM
07-27-2010 08:43 AM
anyone?
07-27-2010 09:46 AM
What are the called and calling numbers???
07-27-2010 10:21 AM
calling number - FXS x18701
called number = call manager phone x11399
Thanks
07-27-2010 10:36 AM
Please put no digit-strip the dial-peer 3 and remove the forward digits and test it again, if does not works collect debug voice ccapi and debug vpm signal at the same time while trying to make a call
07-27-2010 10:56 AM
07-27-2010 11:07 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide