Hi,
Just wondering if anyone has experience the follwoing.
For some reason when i enter the follwoing commands they don't show in my config. I don't get an error message when i enter them and i can also enter different types which are visible when i do a sho run. Also when i enter the cptone US command on the voice port the command doesn't show.
controller T1 0/0/0
framing esf
linecode b8zs
Here's my relvant config.
card type t1 0 0
!
network-clock-participate wic 0
network-clock-select 1 T1 0/0/0
!
isdn switch-type primary-ni
!
!
!
controller T1 0/0/0
cablelength long 0db
pri-group timeslots 1-24
description *** ISDN XX ***
!
controller T1 0/0/1
cablelength long 0db
!
interface Serial0/0/0:23
no ip address
encapsulation hdlc
isdn switch-type primary-ni
isdn incoming-voice voice
no cdp enable
!
voice-port 0/0/0:23
The IOS is c2800nm-spservicesk9-mz.124-24.T5.bin and the module is VWIC2-2MFT-T1/E1
Any help woul be much appreciated as i've never had to configure ISDN for the US.
Cheers,
