06-28-2018 01:01 AM - edited 03-17-2019 01:06 PM
Hi All
When setting up a SIP trunk to an ISP using a CUBE, What kind of details do you normally put in?
I am guessing you need a session target IP for the ISP?
Do they also have to configure the same from their end and point to an IP that you give them?
06-28-2018 03:54 AM
Yes you will configure on your CUBE:
-session target ipv4:@《remote ip @》
-Destination pattern XXX
-Perhaps you will need transformation profile too.
-session protocol sipv2
On the other hand they will need the ip @ of your CME in order to configure the trunk sip.
06-28-2018 04:41 AM
I would suggest starting with the CUBE configuration official guide:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/voice/cube/configuration/cube-book.html
which covers all details.
06-28-2018 06:28 AM
http://docwiki.cisco.com/wiki/CUBE_FAQ#Training_resources
06-28-2018 07:36 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide