Configuring the SPA122 ATA to operate with the CUCM

[alfalah]

how to Configuring the SPA122 ATA to operate with the CUCM

[Sadav Ansari]

Hi,

You can configure Cisco SPA122 or any third party SIP device as a "Third-Party SIP Device (Basic)" or "Third-Party SIP Device (Advanced)". Here is the URL for configuring Cisco SPA112 with CUCM. The steps are same for configuring Cisco SPA122 or any third party SIP device.

https://community.cisco.com/legacyfs/online/legacy/1/1/5/79511-spa112withCucm_04052013.pdf

Pls rate if its “Helpful”. If this answered your question pls click “Accept as Solution”.

Thanks 

Sadav Ansari 

[Nithin Eluvathingal]

Register the SPA as third party device. Follow the Guide shared by other member.