CUCM 4.1 bulk Configuration Export

[saurabh_om]

Hello,

Is there any utility available to export CUCM 4.1 configration in Excel as we do in cucm version 7.x, 8.x and 9.x with bulk export utility.

Thanks

Saurabh       

[Hermanus Janse van Vuuren]

You should get the DMA 4.1 tool on Cisco website.

Look at the following Thread.

https://communities.cisco.com/thread/10412?start=0&tstart=0

[Manish Gogna]

Hi Saurabh,

You can BAT version 5.1(4) which is compatible with CUCM 4.1.x. Details of the export utility are explained in the link below

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/bat/5_1_4/bat_exp.html

Also, if you use DMA it can only be used during the install of a linux based cucm version when it asks for the dma file during the initial stages of installation, the DMA tar file cannot be used anywhere else.

HTH

Manish