10-23-2012 02:45 AM - last edited on 03-25-2019 08:18 PM by ciscomoderator
Hi all
The question is about changing CUCM 7.X IP subnet mask.
We are usign thi guide:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/install/7_1_2/ipchange/ipchg712.html#wp41994
After CUCM restart the IP subnet mask remains the same.
Ideas?
Kind regards.
10-23-2012 12:24 PM
Hi
Did you tried changing the subnet mask via web-interface or the CLI ?
Also i would like to know are you using Physical Server or VMware based server , because changing the subnet in case of VMware server would mean changing the License file.
Please find the command below to change subnet via CLI :
set network ip eth0 same-ip new-subnet-mask |
10-23-2012 11:45 PM
Hi
I did it via web interface and via CLI.
I have a physical server.
I have used the same command.
Kind regards.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: