dial-peer pots incoming redirect

[Vincenzo Errante]

there is a command that is equivalet to the connection PLAR of the voice port, for the dial-peer pots ??.

my problem is that i want to connect an ephone with a specific called isdn number.

the isdn bri haven't DID.

[paolo bevilacqua]

Hi, the simpler way is to add the called number as "secondary" under ephone-dn.

This assume you're using CME, if not, please clarify.

[Vincenzo Errante]

yes is a CME,

ok i use a dial-peer that not use a incoming called-number but destination-pattern ?

[paolo bevilacqua]

You don't need any DP. Either configure secondary number for DN as suggested above, or translate the called number to an extension number, via voice translation-profile and translation-rule.

As an appreciation to those providing answers, please rate useful posts with the scrollbox below!

[Vincenzo Errante]

the conf not work the isdn not go to up

see the debug

[paolo bevilacqua]

Have you associated the ephone-dn to an ephone via button command ?

Note, generally you want to use dual-line ephone-dn, else you won't be able to do consultive transfer, call-waiting, etc.

[Vincenzo Errante]

yes i have to change the dn with dual-line but the result it's the same

ephone 18

mac-address 001B.5452.FC51

type 7911

button 1:31

[paolo bevilacqua]

Please send output of "show ephone 001B.5452.FC51" and if it is REGISTERED send output of "debug isdn q931". No other debugs are to be enabled.

[Vincenzo Errante]

see the attachment

[paolo bevilacqua]

Please send output of "show diag". You might be using a WIC BRI card for data, or not have the necessary PVDM2 card. See:

Jun 9 16:51:21 UTC: ISDN BR3/1 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x9C

Cause i = 0x80AF - Resource unavailable, unspecified

[Vincenzo Errante]

see the attachment :)

[paolo bevilacqua]

Hi, you have 1 of:

PVDM-256K-4=

That is enough for 4 calls, meaning 2 x ISDN BRI, but you have four ports of this kind currently installed.

Then you have:

1 x PVDM-12=

But that is the wrong type for a 1760, and is not supported, see:

http://www.cisco.com/en/US/products/hw/routers/ps221/products_tech_note09186a00800c3399.shtml

So:

- Remove PVDM-12 in internal slot 1

- Remove VIC-2BRI in either slot 2 or slot 3.

And you should be able to call. To use the additional BRI ports, you need to obtain another PVDM-256K-xx

Hope this helps, please rate post if it does!

[Vincenzo Errante]

ok,

but if i use bri 2/1 with primary number and then i use dn with the primary number, the bri go to up but not to go with the dn and ephone.

[paolo bevilacqua]

Sorry, I don't understand that. What I can tell you is that the error message is due to insufficient PVDM resources.

[Vincenzo Errante]

well see the attachment

(out call with this PVDM are all ok and are ok if I use bri associated with ivr)