I recently got an old 1760-v that I am seeting up in the lab. I'm wondering if there may be a bad DSP chip in it. Initially, it had a single DSP
chip in slot 1:
NAME: "DSP Module", DESCR: "Packet Voice DSP Module with 1 C549 DSPs"
PID: Packet Voice DSP Module with 1 C549 DSPs, VID: 3.2, SN: VIC084153D6
I have a two port FXO card in slot 2, but the voice ports never showed up in the config.
I have now added another DSP chip in slot 0:
NAME: "DSP Module", DESCR: "Packet Voice DSP Module with 3 C549 DSPs"
PID: Packet Voice DSP Module with 3 C549 DSPs, VID: 2.2, SN: ICP0331010E
The voice ports have shown up and seem to work, but the original DSP does not seem to come up.
SVG2#show voice dsp voice
DSP DSP DSPWARE CURR BOOT PAK TX/RX
TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT
==== === == ======== ======= ===== ======= === == ========= == ===== ============
C549 000 00 g711ulaw 4.1.43 Idle Idle 0 0 2/0 NA 0 62/17
C549 000 01 g711ulaw 4.1.43 Idle Idle 0 0 2/1 NA 0 8/11
Active Voice Call details
Current total analog signalling channels: 2
Current max allowed digital timeslot for voice: 12
Current active transcoding sessions: 0
Current free transcoding sessions: 0
Current active conferencing sessions: 0
Current free conferencing sessions: 0
Current number of DSP group: 1
Group 0:
Current allocated analog signalling channels: 2
Current free analog signalling channels: 0
Current allocated digital signalling channels: 0
Current free digital signalling channels: 12
Port(s) served: 2/0 2/1
Current Available MIPS: 300
SPMM DSPRM State Image D-sig D-sig A-sig A-sig Mips Voice/Xcode
Dsp Dsp allocate free allocate free Free Chan
0/0 0 UP FIXHC 0 0 2 0 100 0
0/1 1 UP FLEX6 0 6 0 0 100 0
0/2 2 UP FLEX6 0 6 0 0 100 0
1/0 3 FLEX6 0 0 0 0 0 0
SVG2#show voice dsp error
No DSP errors logged
Any ideas? Am I missing something?
