01-10-2015 09:44 AM - edited 03-17-2019 01:32 AM
Here's the scenario, and I apologize if my terminology is wrong.
Incoming Call from PSTN via ISDN/PRI -> Translation from 4466 to ephone-hunt sequential at 1001 -> ext 1 -> ext2 -> ext3 -> ext4-> AA at 8010 -> viop dial-peer to SBC -> SBC to O365 UM service -> AA picks up -> User dials 2, nothing happens
If I translate directly from 4466 -> 8010, works perfectly. Stumped here.
I have attached the relevant bits of config (hopefully properly sanitized). ISR is a 2921 running 154-2.T1.
01-15-2015 01:44 PM
I have now noted it is not just the AA, it is any call to the SBC/VM that does not get DTMF relay. It is only when transferred through a phone. I set the front desk (4466) ext 2001 to receive night bell and set call-forward night to AA pilot and it worked perfectly.
01-28-2015 04:17 PM
I cant believe no one has any ideas. Did I post this in the wrong group?
This weekend I setup another config almost identical to this one with no issue. Same commands, same SBC, only 2 differences were a 2911 instead of 2921 and it's a different Telco.
02-05-2015 12:37 PM
This is solved. The issue with the Telco. They were sending me out of band DTMF, when changed to in band, the issue was resolved.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide