11-27-2012 11:27 PM - edited 03-16-2019 02:25 PM
Hello All,
I have an E1 link from my provider with the pool of numbers 335059xx and want to configure my E1 and CCME to do the translation
Can someone kindly hint me
Thanks
11-27-2012 11:48 PM
Plz refer below link for basic conf.
11-27-2012 11:59 PM
Hi Divine,
An easy way of mapping the pool of DIDs to extensions is by using the following command under telephony-service:
dialplan-pattern tag pattern extension-length extension-length [extension-pattern extension-pattern | no-reg] [demote]
Please refer the following link for more details on how to configure this:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/command/reference/cme_d1ht.html#wp1061986
HTH.
Regards,
Harmit.
11-29-2012 02:36 AM
Am in Cameroon and i have thesame issue here is my config
controller E1 0/1/0
linecode ami
pri-group timeslots 1-16
!
interface Serial0/1/0:15
no ip address
encapsulation hdlc
isdn switch-type primary-net5
isdn incoming-voice voice
no cdp enable
!
dial-peer voice 54 pots
destination-pattern 0T
port 0/1/0:15
incoming called-number .
direct-inward-dial
!
isdn test call interface serial 0/0/0:15 00023775697183
Here is my error message
Nov 29 10:35:42.928: ISDN Se0/1/0:15 EVENTd: isdn_is_bchannel_available: No Free B-channels
Nov 29 10:35:42.928: ISDN TEST CALL #0 to 0023775697183 at 64 Kbps failed aborting the remaining 1 calls
my card is NM-2CE1T1-PRI on a 2800 series router
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide