|Step 1||From the Cisco Unified Communications Manager Administration, select Device > Phone.|
|Step 2||Locate your phone.|
|Step 3||In the Product Specific Configuration Layout, set the Web Admin parameter to Enable.|
|Step 4||In the Admin Password field, enter a password.|
|Step 5||Select Save and click OK.|
|Step 6||Select Apply Config and click OK.|
|Step 7||Restart the phone.|
I have not yet connected this phone to the WLAN. I need to configure the certificates in order for the phone to connect to the AP via EAP-TLS, but the phone admin page via USB is disabled. How, can I enable the admin page without using CUCM??
I have the same issue as LoreZyra0, I need to upload a User Certificate to get on the WLAN then I can connect to the CUCM to release this. I tried a factory reset (END & #, wait till LED is RED, then 123456789*0# and no change to that setting. From what the DOCS say, the phone will not register to the CUCM from the wired connection on the docking station, so how will that help? The only web page I am seeing is the status page. I was able to config on the one I had prior, but had to RMA that one as it was corrupt. So, I have done the Certificate process before.