ā04-17-2011 01:26 PM - edited ā03-16-2019 04:33 AM
Is there a way to configure ephone-dn as a single line in CME? it looks like the default is dual line...
Basically user wants the second incoming call to go directly to the VM while on the line...
Thanks,
Solved! Go to Solution.
ā04-17-2011 01:36 PM
its a single line with two channels, put the 'huntstop channel' command under the dn
please rate helpful posts
ā04-17-2011 01:36 PM
its a single line with two channels, put the 'huntstop channel' command under the dn
please rate helpful posts
ā04-17-2011 02:48 PM
Works perfect - Thanks a lot for the input.
ā04-18-2011 03:39 AM
Hi
This option is perfect.
Regards
Lavanya
ā04-17-2011 01:41 PM
Hello,
If the e-hone-dn command has no dual-line or octo-line , it should be only one ???
check the command link :
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/command/reference/cme_e1ht.html#wp1046376
Ephone-dns are created in single-line mode if the dual-line or octo-line keyword is not used.
Amer
ā04-17-2011 02:54 PM
tried the following for testing purpose and call went directly to vm.
ephone-dn 48
number xxxx
label - Admin - xxxx
name Admin
allow watch
call-forward busy 8000
call-forward noan 8000 timeout 20
corlist incoming user-international
hold-alert 30 originator
ā04-18-2011 10:06 AM
What is the config for the ephone?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide