06-09-2010 02:51 PM - edited 03-15-2019 11:10 PM
I have a 2811 VGW registered to CUCM 7.02, is it an H.323 gateway. Local PSTN is coming in on a PRI circuit connected to the VIC-2TMFT-T1/E1. One of the inbound numbers on that PRI is a fax number (5551236789) that I need to port out of the FXS card (voice-port 0/2/0) to the fax machine. Also need to allow for outbound fax sending.
Would someone mind posting sample config that will help me understand and accomplish this? I find plenty of examples, but don't completely understand what is pertinent for creating both inbound/outbound config.
!
dial-peer voice 21 pots
description Fax
destination-pattern 5551236789
port 0/0/0:23
forward-digits 0
codec g711ulaw
fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback cisco
fax rate voice
!
!
voice-port 0/2/0
translation-profile incoming Fax
description Fax
!
Regards,
Jason
Solved! Go to Solution.
06-10-2010 03:59 AM
First, your incoming dial peer should cover all incoming calls on the PRI and include the direct-inward-dial command. This will cover you for the inbound call leg. The outbound dial peer could look something like this:
dial-peer voice 21 pots
description Fax
destination-pattern 5551236789 <-- This assumes that the provider is sending you 10 digits on the PRI.
incoming called-number . <-- This is used to match this as an incoming dial peer for outbound faxes.
voice-port 0/2/0
codec g711ulaw <-- used for passthrough
fax rate voice <-- used for passthrough
fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback cisco <--used for fax relay
You do not need both the passthrough or relay commands. I would recommend just using the relay command.
06-09-2010 02:56 PM
You don't need any fax commands for that.
Just configure the DP with the right numbers, and that's all.
06-10-2010 03:59 AM
First, your incoming dial peer should cover all incoming calls on the PRI and include the direct-inward-dial command. This will cover you for the inbound call leg. The outbound dial peer could look something like this:
dial-peer voice 21 pots
description Fax
destination-pattern 5551236789 <-- This assumes that the provider is sending you 10 digits on the PRI.
incoming called-number . <-- This is used to match this as an incoming dial peer for outbound faxes.
voice-port 0/2/0
codec g711ulaw <-- used for passthrough
fax rate voice <-- used for passthrough
fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback cisco <--used for fax relay
You do not need both the passthrough or relay commands. I would recommend just using the relay command.
06-10-2010 07:34 AM
Thank you Jonathan.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide