foreign configuration

[shaikhmuzzamil005]

As hardware was indicating the amber light. . So Tac team advised to swap the drive but after swapping the hard drive from slot no 4 to 8 its not rebuilding itself and stuck in foreign configuration. but the disk condition is good. how can i bring it online and make it rebuild itself. Its more than 3 hours and its 500GB HDD & configured in RAID 10.

We are using BE 6000 call manager.

server is making a sound

[Manish Gogna]

I am not too sure about what all has been done with this BE6000 server but the recommendation related to the foreign configuration is outlined on page 129 of the following doc

http://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/c/hw/C220/install/C220.pdf

Manish

- Do rate helpful posts -