10-02-2012 07:55 AM - edited 03-16-2019 01:28 PM
Hey,
running FXS ports on CME 7 and I am trying to configure a Fax machine to hang off the FXS port. I keep getting a busying signal when calling in bound. the translation is for DN 109
voice translation-rule 1
rule 1 /8866/ /700/
rule 2 /8183/ /401/
rule 3 /8896/ /896/
rule 4 /8109/ /109/
Then I have
voice translation-profile TranslateDID translate called 1
Then on the voice-port I have
voice-port 0/0/0
signal groundStart
connection plar 109
Can someone take a look and see what I might be missing?
Replies rated!
10-02-2012 07:58 AM
Should be singal loopstart, and no connection plar.
You will need a dial-peer pots to send calls to 109 to the port.
Or eliminate the translation rule and send calls what whatever number is received by telco.
10-02-2012 08:33 AM
Thanks Paolo,
Here is my dial-peer but I am still getting a buy signal
dial-peer voice 10 pots
translation-profile incoming TranslateDID
translation-profile outgoing profile1
destination-pattern 109
incoming called-number 109
fax rate voice
direct-inward-dial 109
10-02-2012 08:58 AM
I'm afraid you have some confusion here and there, seems like you weren't sure how it should be done so there is a lot of 109s around.
10-02-2012 07:01 PM
Hi!
You just need:
Dial-peer 109 pots
Destination-pattern 109
Port 0/0/0
Voice-port 0/0/0
Signal loop
Any other digit manipulation is to make the line reachable from PSTN.
HTH
--
Jorge Armijo
Sent from Cisco Technical Support Android App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: