FXS "Dial 9" use PRI outbound config assistance on H.323 GW

[jeremyrcarr]

I need some assistance on setting up some FXS Ports.

I have zero experience with H.323 configuration as I've always had my gateways managed my MGCP.

What the customer is looking for is for a number of FXS ports to be configured with outbound dial-tone by pressing 9 and having the ability to make phone calls. It's for a postal machine and doesn't require inbound dialing, only outbound.

I've attached the config of the device, any assistance on this would be awesome.

Thanks!

[Jonathan Schulenberg · Accepted solution]

H.323 is only really needed if you're going to route the calls toward CUCM. If the gateway has both the FXS ports and the PSTN-facing ports in it you can accomplish it with just dial-peers. Here are the two docs to get you going for H.323:

Cisco IOS H.323 Configuration Guide

Cisco IOS H.323 Configuration for Use with Cisco CallManager

H.323 Configuration Template

[jeremyrcarr]

Thanks Jonathan!

I'll check those out.