H.323 and partial E1

[dszymkowicz]

Hi,

Is it possible to configure E1 on H.323 GW to use for example all 30 channels for incoming calls and 25 for outgoing?

regards

[acampbell]

Hi,

Yes you can select some timeslots for OUTGOING.

You need to use trunk groups

Something like this

!

trunk group OUTGOING

!

!

controller E1 0/0/0

pri-group timeslots 1-31

trunk-group OUTGOING timeslots 21-31

!

dial-peer voice 9 pots
trunkgroup OUTGOING

tone ringback alert-no-PI
description *** O/G LEVEL 9 TRAFFIC TO PSTN ***
destination-pattern 9T
progress_ind setup enable 3
progress_ind alert enable 8
progress_ind progress enable 8
progress_ind connect enable 8
incoming called-number .
direct-inward-dial
!

HTH

Alex

[dszymkowicz]

For now  I cannot test it. Is it possible to limit also incoming calls the same way?

Is it depended from channel selection order (which is configured on provider side)?

[acampbell]

Hi,

Sorry you can not control the INCOMING.

This is controlled by your PRI service provider.

Regards

Alex

[dszymkowicz]

Thanks a lot for help.

[Chris Deren]

Alex,

I have a similar requirement but I do not see an option to add trunk-group under controller. Did you ever test it, did it work?  Any other suggestions?

Chris

[acampbell]

Chris,

Yes this works for me.

PM message sent to you.

Check your inbox

Regards,
Alex.
Please rate useful posts.

[Chris Deren]

Thanks Alex, my issue was that the trunk group was already assigned to serial interface, as soon as I removed it from serial it was available under controller.

Chris