H323 to IP phone dial peers

[TomMar1]

Not sure what I am missing here to place call from an H323 device to an IP phone.

Here are the dial peers I have, I want to be able to call from H323 port on a VG320 to IP Phone x11112

dial-peer voice 111 voip
description H323 testing
destination-pattern 11112
session target ipv4:IP of Subscriber where phone is registered
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
!
dial-peer voice 112 voip
description Call any 5 digits number
destination-pattern [1]....
session target ipv4:IP of Subscriber where phone is registered
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad

Any assistance would be greatly appreciated.

[Jonathan Schulenberg]

Is the CallManager Group, by way of the Device Pool, assigned to the H.323 Gateway in CUCM the same as the session-target address you have defined? If not CUCM will drop the H.323 traffic.

[TomMar1]

Yes, the CUCM group which contains the CM sub's that match the session target(s) are assigned.  The PUB is not included in any CM group.

[Scott Leport]

Hi,

Can you dial other extension numbers from the H.323 gateway that are matched on dial-peer 112? Can you also dial the extension 11112 from other phones / locations which may be registered on your Call Manager cluster?

If you run the debug voip ccapi inout command on the H.323 gateway, what does that say?