How to connect two router with E&M cards

[connect101]

Hello,

I have two router : a 3745 with VIC-2E&M and a 1751V with VIC-2E&M.

I want to tranfer call from the 1751V to the 3745 with these cards.

(router )E&M <-> E&M (router)

Is it possible?

How to do? How about connector and pinouts

Thenk you very much.

[pcameron]

Make sure the router chassis have a common electrical ground connection (very important for E&M) and use a console rollover cable. Refer here for details -

http://www.cisco.com/en/US/tech/tk1077/technologies_tech_note09186a0080093f5e.shtml#rollovercable

This will allow you to make calls between the two devices. E&M trunks won't give you supplementary services like transfer/hold/call forward.

[connect101]

Thank you very much.

[paolo bevilacqua]

Pinout:

http://cisco.com/en/US/tech/tk1077/technologies_tech_note09186a00800942ef.shtml

and technology primer:

http://cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a0080094ab9.shtml

Hope this helps, please rate post if it does!

[connect101]

Thank you very much.

All your responsee have resolved my issue.

Thank you

Thank you

Thank you