cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays
451
Views
0
Helpful
4
Replies
Ahmed habib
Participant

Implementing SAF on CUCM Clusters

Hello,

I want to implement SAF on cucm clusters but I don't under the scenario and how will configuration be done and how did I check after configuration

Shall I configure every cucm cluster PUB as SAF Forwarder?

I revised SRND and SAF configuration document but it isn't clear to me https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/saf/configuration/xe-3s/saf-xe-3s-book/saf-configuring.html

Please, I want a clear document or video for this feature scenario and configuration

Note: I made the configuration in the guide but when I check I found

#show eigrp service-family ipv4 subscriptions
EIGRP-SFv4 VR(saf) Subscriptions for AS(1)/ID(192.168.178.125)
No active subscriptionsW

#show eigrp service-family ipv4 clients
EIGRP-SFv4 VR(saf) Clients for AS(1)/ID(192.168.178.125)
No Clients attached to this Forwarder

 

 

4 REPLIES 4

SAF has been superceeded by Inter-Cluster Lookup Service (ILS). Do not use SAF in production unless you have a corner-case that somehow precludes the use of ILS.

1) Below Will be useful for ILS
https://www.youtube.com/watch?v=CnSuho44_dw

https://info.stack8.com/blog/new-practices-for-cucm-dial-plans

*** Please rate helpful post; Mark "Accept as a Solution" if applicable

Thanks,
Haris

Thanks both for your interest but I don't want URI dialing

I just want to use SAF and CCD and I applied the configuration but when I try show commands 

show eigrp service-family ipv4 clients
EIGRP-SFv4 VR(saf) Clients for AS(1)/ID(192.168.178.125)
No Clients attached to this Forwarder

 

GW#show eigrp service-family ipv4 subscriptions
EIGRP-SFv4 VR(saf) Subscriptions for AS(1)/ID(192.168.178.125)
No active subscriptions

 

GW#show eigrp service-family external-client Habib
Detail data for client -- Habib
Username: admin Version: 1.2
Client Context: AS (1): AFI: IPv4 Topology: Base
Router Name: saf
Config Using as Client Basename

 

I made the configuration on two cucm test clusters but no one is active

Can anyone help me ?

 

 

router eigrp saf
!
service-family ipv4 autonomous-system 1
!
topology base
external-client Habib
external-client Habib1
exit-sf-topology
exit-service-family

 

service-family external-client listen ipv4 5050
external-client Habib basename
username admin
password ..............
keepalive 200000
!
external-client Habib1
username admin
password ............
keepalive 200000

@HARIS_HUSSAIN  @Jonathan Schulenberg 

 

I got finally the two clients registered

Is there a method to show the patterns learned on cucm or must show on RTMT ?

and Is should add manually every pattern I need to advertise ?

and Calls are done from one side only , if dialed from the other it gets fast busy tone although the learned pattern shown and all is reachable

Content for Community-Ad

Spotlight Awards 2021