Inbound and outbound calls with CUCM

[Akaffou Aristide Akaffou]

Hi guys,

I have the problem with inbound and outbound calls with CUCM.

Your help will be precious.

Thanks

Regards,

Aristide

[Nadeem Ahmed]

Aristide

Can you please share some details in order understand what exactly is the problem

Call-flow ? where you phone registered to CME or CUCM, what error message you get you dial out the number?

Br,
nadeem

[Akaffou Aristide Akaffou]

Hi Nadeem, 

the phone are registered in CUCM, I think they can be a config mismatch.

this is debug isdn q931

Oct 26 19:55:21.525: ISDN Se0/0/0:15 Q931: RX <- SETUP pd = 8  callref = 0x0527
        Sending Complete
        Bearer Capability i = 0x8090A3
                Standard = CCITT
                Transfer Capability = Speech
                Transfer Mode = Circuit
                Transfer Rate = 64 kbit/s
        Channel ID i = 0xA98385
                Exclusive, Channel 5
        Calling Party Number i = 0x2183, '664072581'
                Plan:ISDN, Type:National
        Called Party Number i = 0xC1, '624931980'
                Plan:ISDN, Type:Subscriber(local)
Oct 26 19:55:21.525: ISDN Se0/0/0:15 Q931: TX -> RELEASE_COMP pd = 8  callref = 0x8527
        Cause i = 0x80E4 - Invalid information element contents

Br,

Aristide

[Nadeem Ahmed]

can you please post the show run from GW and also how your GW is controlled by CUCM (MGCP,H.323, SIP)

Br,
nadeem

[Akaffou Aristide Akaffou]

Hi Nadeem

You can see the configuration of the router in attached.

br

Aristide

[Nadeem Ahmed]

can you please make another test call inbound and outbound and collected below debugs

Debug isdn q931

debug mgcp packet

debug mgcp events

debug ip tcp transcation

also post the show isdn status

[Akaffou Aristide Akaffou]

Hi Nadeem

you can see debug in attached

[Nadeem Ahmed]

Thanks for the details and debug logs. can you please check E1 configuration on CUCM? also can you attached the snapshot of E1 configuration on CUCM

[Nadeem Ahmed]

one thing need to confirm, is the switch type correct which needs to be same on the other side as well.

Br,

nadeem

[Akaffou Aristide Akaffou]

thank you Nadeem,

I will give you a feedbak today.

[Akaffou Aristide Akaffou]

hi Nadeem,

I have don't configured calling search space and partitions. It can be the issue?