Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have a problem to establish call session between over gre tunnel ipsec. The tunnel is up but I am Unable to set a call. I think the problem is Nat but I don't know how to fix it.
You can see the configuration files in attached.
Best Regards,
...
Hi,
I have authentication problem with windows 8 and 10 clients in ISE 2.2.
Windows 8 and windows 10 clients can not have access to the network at the first authentication. We must lockout and unlock to have access to the network. I used external ide...
Hi,
I have deployed Cisco ISE 2.2. I have a problem with windows 8 and windows 10 devices. Their authentication failed at the first log in, but when you lock out and lock in, their authentication pass.
I want to make a downgrade from ISE 2.2 to ISE ...
Hello,I have a problem with call transfer after deploying cisco voice ISR4331V. When I try to transfer a call to another staff, the call goes on hook.You can see my configuration and please let me know if there is an issue somewhere.Comar_voip#sh run...
Hello,I am deploying ISE2.2, and I have a problem with windows 10 PC. 802.1x authentication failed. I have made some changes in PCs registry, I have added TLS1.2 in the registry but it still remain the same. I have no problem with windows 7 and 8.Can...
Hello kamlenegi,
I have fixed this issue. I have just reconfigured windows supplicant for windows 10.
Just uncheck " Enable single sign on for this network" on the supplicant configuration.
You have to disable port security on the switch too, if i...
Hi all,
I have resolved the issue
Firstly I have configured native supplicant profile on cisco ISE.
Secondly, I uncheck "Enable single sign-on for this network" in the supplicant windows configuration. Finally all is work fine now.
Best Regards,
...
