Increasing E1 line

[mesarasimth1]

Hi

We had increased our E1 line from one to two. But as soon as we connected the second line, all lines failed to function normally. Is it because of wrong serial interface configuration?

Thank You 

[Arun Prakash Sharma]

Please Use this configuration for PRI

card ty e1 0 0
network-clock-parti wic 0
network-clock-sele 1 e1 0/0/0
isdn sw primary-net
exit

controller e1 0/0/0
framing c
linecode h
pri tim 1-4 ser mg
no sh
ex

int s0/0/0:15
isdn bind-l3 ccm
isdn out dis
isdn out ie re
no sh
ex

voice-p 0/0/0:15
no sh
ex

[Abhay Singh Reyal]

Provide show run and show inventory 

Regards

Abhay