07-24-2014 07:36 PM - edited 03-16-2019 11:31 PM
If you have a DID feature from an ISP, can you only use a DID based voice interface card?
Thanks in advance again :)
Solved! Go to Solution.
07-25-2014 06:11 AM
Yes, you can do that.
You need to configure did signal on that particular voice port.
Please refer the link for same
http://www.cisco.com/c/en/us/support/docs/voice/analog-signaling-e-m-did-fxs-fxo/24760-confg-vic-2did.html
regds,
aman
07-24-2014 11:42 PM
thats true.
in analog voice port, FXS-DID are famous.
http://www.cisco.com/c/en/us/support/docs/routers/2600-series-multiservice-platforms/15268-vic-2did.html
~chintan.
07-25-2014 12:00 AM
Hi John,
You can also refer the link
http://www.cisco.com/c/dam/en/us/products/collateral/routers/2800-series-integrated-services-routers-isr/product_data_sheet0900aecd8057f2e0.pdf
regds,
aman
07-25-2014 05:08 AM
Hi John,
you can also refer the link
http://www.cisco.com/c/en/us/products/collateral/routers/2600-series-multiservice-platforms/product_data_sheet09186a00800921e7.html
regds,
aman
07-25-2014 05:38 AM
Thanks Aman. I had seen that link.
Can DID devices also be used for connecting Cisco phones to routers?
07-25-2014 05:47 AM
Hi John,
DID is a basically a service which is offered by TELCO and same needs to be supported on Voice cards.
on these cards , you have voice ports and not ethernet ports.
Cisco IP phones need to be connected to switch.
regds,
aman
07-25-2014 06:02 AM
That's correct.
And then I guess configure vic-2did in router to receive did calls from ISP. Correct?
07-25-2014 06:11 AM
Yes, you can do that.
You need to configure did signal on that particular voice port.
Please refer the link for same
http://www.cisco.com/c/en/us/support/docs/voice/analog-signaling-e-m-did-fxs-fxo/24760-confg-vic-2did.html
regds,
aman
07-25-2014 06:25 AM
Thanks Aman. Much appreciated. You have made the complex simple
07-25-2014 06:30 AM
Thanks for rating.
[+5] to Chintan for knowledge sharing.
regds,
aman
07-25-2014 04:18 AM
Thanks for your reply Chintan.
And this would apply to a small business using Cisco phones and routers if they wanted to use this method too then?
07-25-2014 04:30 AM
And 1 port could be for fax and the other for voice or both could be used for voice then
07-25-2014 04:40 AM
ports can be used as FXS or DID,
if you are planning to use them as FXS then you can attach fax or telephone or both.
regards
Chintan
07-25-2014 05:04 AM
Thanks Chintan,
No, I was considering Cisco phones attached to routers.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: