lic transfer from 15.0 to 15.2 ios

[aazmi]

hi,

i have 2921 with V/k9 lic. i need to upgrate ios form 15.0 to 15.2. how can i transfer my lic as when i boot from 15.2 is show zero lic.

Regards

Aazmi

[Aman Soi]

Hi Aazmi,

There won't be any need to transfer any license .The software features like data, uc, security which were available in 15.0 , would also be available in 15.2 since the upgradation is being done in 15.X only.

Can u post the output of command show license/show version  after u have booted from both 15.0 and 15.2 versions?

regds,

aman

[aazmi]

ok, let me check as i have reversed the ios. when i did this all my IP Phones say unable to register to cme. i also remenber it was showing 0 lic for uc.

i will again load the 15.2 ios to get the lic status.

thanks

aazmi

[paolo bevilacqua]

This is often asked, had you searched before asking.

Configure "license accept end user agreement".

Reload.

[Ayodeji Okanlawon]

Take a look at this documentation. It explains how licensing in CCME works...

https://supportforums.cisco.com/docs/DOC-26706

Please rate all useful posts

"'Nature is too thin a screen, the glory of the omnipresent God bursts through it everywhere"-Ralph Waldo Emerson

[Jorge Armijo]

+5 aokanlawon!

--
Jorge Armijo

Please remember to rate helpful responses and identify helpful or correct answers.