12-23-2012 09:36 PM - edited 03-16-2019 02:51 PM
hi,
i have 2921 with V/k9 lic. i need to upgrate ios form 15.0 to 15.2. how can i transfer my lic as when i boot from 15.2 is show zero lic.
Regards
Aazmi
12-24-2012 06:04 AM
Hi Aazmi,
There won't be any need to transfer any license .The software features like data, uc, security which were available in 15.0 , would also be available in 15.2 since the upgradation is being done in 15.X only.
Can u post the output of command show license/show version after u have booted from both 15.0 and 15.2 versions?
regds,
aman
12-24-2012 06:30 AM
ok, let me check as i have reversed the ios. when i did this all my IP Phones say unable to register to cme. i also remenber it was showing 0 lic for uc.
i will again load the 15.2 ios to get the lic status.
thanks
aazmi
12-24-2012 06:41 AM
This is often asked, had you searched before asking.
Configure "license accept end user agreement".
Reload.
12-24-2012 02:23 PM
Take a look at this documentation. It explains how licensing in CCME works...
https://supportforums.cisco.com/docs/DOC-26706
Please rate all useful posts
"'Nature is too thin a screen, the glory of the omnipresent God bursts through it everywhere"-Ralph Waldo Emerson
12-24-2012 04:26 PM
+5 aokanlawon!
--
Jorge Armijo
Please remember to rate helpful responses and identify helpful or correct answers.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide