cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2279
Views
33
Helpful
15
Replies

Meet-Me Number and Pattern

vipankapur1
Level 1
Level 1

Hello,

I wanted to know if anyone has step-by-step directions on how to setup Meet-Me Number/Pattern on Cisco Callmanager 7.1.5.

Thank you

2 Accepted Solutions

Accepted Solutions

Chris Deren
Hall of Fame
Hall of Fame

Check you Administrator Guide for step by step directions, but there is very little to it, you go to Meet Me Patterns and define the range using default wildcards i.e. 55XX and assign partition to it. 

HTH,

Chris

View solution in original post

Gajanan Pande
Cisco Employee
Cisco Employee

As Chris mentioned, there is nothing much but here you go with the document " Meet-Me Number/Pattern Configuration "

GP.

Pls rate helpful posts by clicking on stars below the post !!

View solution in original post

15 Replies 15

Chris Deren
Hall of Fame
Hall of Fame

Check you Administrator Guide for step by step directions, but there is very little to it, you go to Meet Me Patterns and define the range using default wildcards i.e. 55XX and assign partition to it. 

HTH,

Chris

Gajanan Pande
Cisco Employee
Cisco Employee

As Chris mentioned, there is nothing much but here you go with the document " Meet-Me Number/Pattern Configuration "

GP.

Pls rate helpful posts by clicking on stars below the post !!

vipankapur1
Level 1
Level 1

Hello,

I have created a extension pool as per the link provided by Gajanan.  I have added the 1st number in the pool to a phone (7945), but I can't dial in from 2 different phones.  Am I doing something wrong or have I forgotten a step?

What do you mean by:

I have added the 1st number in the pool to a phone (7945)

You define these ranges, then to start MeetMe you press MeetMe softkey on the phone and enter a number from this range, i.e. 7526 to start the MeetMe conference, then other calls dial 7526 to join it. Is this what you are doing?

Chris

Chris,

I assigned 7526 to a phone. When I press the MeetMe softkey from another phone, I get 2 quick beeps. I dial the 7526 number and it connects to 7526. But when I dial 7526 from another phone, in order to answer it the 1st phone gets put on hold.

Thanks,

You cannot assign overlapping DNs with MeetMe numbers to phones. You created a conflict. You can assign them as speed dials if you want, but not DNs.

HTH, please rate all useful posts!

Chris

Rob Huffman
Hall of Fame
Hall of Fame

Hi there,

Just to add a note to the great tips from Chris and Gajanan (+5)

- Remove 7526 from the 7945

- go to any phone press new call > MeetMe > 7526 (this will start the conference)

- from other phones dial 7526 and they will be added to meetme conference

Cheers!

Rob