Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Guys have a client with CUCMBE 7.x and some recentley added 7945 Handsets.I have installed the 7945 device pack as per usual and it works fine, however when I try to add a user through User Management > User/Phone Add the 7945 Phone isn't available u...
Dear Community Members,I have the follwing casual scenario: (ext2000+CUCME)-----IP----(ext1000,1001+CUCM). Calls between 2000----1000 and 2000-1001 works fine. From CUCME side to CUCM I am using dial-peer voip with codec g729. And CUCM was CUCME poi...
Hi,I have an environment running CUCM version 7.1. I have successfully created an End User in CM and just could not find an entry being created in Cisco Unity Connection after that.Any solutions would be very much appreciated. Thanks.Regards,Mohammed...
Hello Team,Good afternoon !In this document : http://www.cisco.com/en/US/docs/telepresence/endpoint/software/tc5/release_notes/tc_software_release_notes_tc5.pdfPage 6, it is said that we need CUCM 8.6 to run EX-60, but we have at this moment CUCM 8.5...
Can someone give me guide line for the subject matter. Thanks
Dear All,I am trying to connect CUCM v7.1 to a provider who is using H323.Outgoing from CUCM is working okIncoming not working (DID extension rings, connects, but no audio and get disconnects after 10 seconds, main number connects but no voice greeti...
Can someone give me guide line for the subject matter. Thanks
Hi everyone,We're deploying a CUBE as an SBC to do sip-to-sip to our service provider (CUCM 8.5). I would like any calls that are using internal extensions to use our pilot number for the trunk as any non-valid DID numbers calling out get dropped by ...
I purchsed a 2811 router on ebay with CME installed. Is there any license needed ( e.g. IOS license, feature license, phone user license) before using this equipment in a business environment?Thanks,
Hello All,in the latest versions is the license tied to a MAC address? What needs to be done to migrate to new hardware?Thanks in advance. All replies rated
After upgrade to CME 9.0, GUI access accepts credentials and then proceeds to blank page. I verified Flash files, ip http path etc, and all appear correct.
End user is reporting "I received a voicemail which hit both the voicemail system and my email with the .wav file attached. I used the Viewmail feature from the Outlook preview pane to listen to the message. A few minutes later I opened the messag...
Hi,I am setting up a laboratory of CUCM, and I have two routers, each with an E1 card.Can I connect these two routers E1 through that door? If so, which cable is used?thank you!!!!!Bruno
Hello,just a quick question..Imagine that there are two managers (A and B).There is only one secretary for them (C).The two manager's devices are configured to forward calls (busy or no answer) to the secretary.Imagine that a customer (D) calls e.g m...
Hello everyone,I have configured snr at a customers location to ring on his mobile and ip phone on UC 560.He says that whenever he is recieving calls and answering the callswith his mobile the Ip phone keep ringing until the reciever is picked.Is the...
