cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
271
Views
0
Helpful
4
Replies
Highlighted
Beginner

mobility profiles- logout?

HII all,

I Have set up mobility profiles for metting rooms, and are workign fine the problem is I do not have an option to logout of the profile once signed in I am using Cisco IP Phone 7940 series.

I must be missing a setting somewhere can somebody point me in the right direction? I am using call manager version 7

Thanks in advance.

Martin

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted

go to the User Device Profile page and assign the EM phone service to the user- top right of page - drop down menu

the fact you can log in  means the end user page configuration is correct so it is just the UDP missing the EM phone service  

View solution in original post

4 REPLIES 4
Highlighted
Frequent Contributor

It sounds like you need to assign a EM service to the UDP profile as well so they can use the service to log out

Highlighted

Thank you for your reply and sorry to be thick, but I havetn been using Call manager long(couple of days) could you break that down a bit for me.

Thanks

Highlighted

go to the User Device Profile page and assign the EM phone service to the user- top right of page - drop down menu

the fact you can log in  means the end user page configuration is correct so it is just the UDP missing the EM phone service  

View solution in original post

Highlighted

Thank you very much, you have just made my day alot easier.

Thanks.

Content for Community-Ad