cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays
112
Views
0
Helpful
4
Replies
dtom
Beginner

Move VG224 to a different Subscirber

We have two CUCM Groups:

Sub1-CMG

  Subscriber-1

  Subscriber-3

Sub2-CMG

  Subscriber-2

  Publisher

We have a vg224 that is connected to SUB1-CMG with the following:

!
sccp local FastEthernet0/0
sccp ccm cucm-sub1.staff.fusd.local id 1
sccp ccm cucm-sub3.staff.fusd.local id 2
sccp ccm 10.112.160.2 id 3
!
ccm-manager config server cucm-sub3 cucm-pub1
ccm-manager config
ccm-manager sccp local FastEthernet0/0
!
sccp ccm group 1
  bind interface fa0/0
  ass ccm 1 priority 1
  ass ccm 2 priority 2
  ass ccm 3 priority 3
  switchback method graceful
!
voice service voip
!
stcapp
!
sccp
!
ccm-manager sccp
!

We want to move the vg224 to Sub2-CMG and changed group from Sub1-CMG to Sub2-CMG and the configuration to:

!
sccp local FastEthernet0/0
sccp ccm cucm-sub2.staff.fusd.local id 1
sccp ccm cucm-pub1.staff.fusd.local id 2
sccp ccm 10.112.160.2 id 3
!
ccm-manager config server cucm-sub3 cucm-pub1
ccm-manager config
ccm-manager sccp local FastEthernet0/0
!
sccp ccm group 1
  bind interface fa0/0
  ass ccm 1 priority 1
  ass ccm 2 priority 2
  ass ccm 3 priority 3
  switchback method graceful
!
voice service voip
!
stcapp
!
sccp
!
ccm-manager sccp
!

After this was done, the vg224 would not register to Subscriber-2.

What are we missing here?

1 ACCEPTED SOLUTION

Accepted Solutions
Chris Deren
Hall of Fame Master

Does the device pool assigned to the SCCP ports in CUCM includes the same CUCM nodes in its CUCM group?

View solution in original post

4 REPLIES 4
Dennis Mink
Advisor

after the change, reset the gateway in CUCM and restart the box, see if that makes a difference

Please rate if helpful

Please remember to rate useful posts, by clicking on the stars below.

Manish Gogna
Cisco Employee

You can try a no sccp / sccp after making changes in SCCP config.

Manish

Chris Deren
Hall of Fame Master

Does the device pool assigned to the SCCP ports in CUCM includes the same CUCM nodes in its CUCM group?

View solution in original post

That was it.  Thanks.

Content for Community-Ad

Spotlight Awards 2021